Everyone may know that the clothing anti-theft device is often seen when we go shopping for clothes in life. Its anti-theft effect is very good. The businessman who opens the store, as the person who deals with him from morning to night, will always use it in the process. Encountering various problems, many friends asked why the power supply of clothing security doors is always burned out? Next, I will briefly tell you:
There are several reasons why the power supply of the clothing security door always burns out: the quality of the power cord of the anti-theft induction door is not up to standard, the power is overloaded, and the power cord is aging and short-circuited. In fact, these reasons are all caused by a common hidden danger, that is, many businesses will set the power supply of the anti-theft device and the power supply of other electrical appliances to the same when installing the clothing anti-theft device, which may save a lot of installation costs and wiring. However, it has laid a landmine for the electricity safety of the entire store.
If the power cord of the anti-theft induction door is not up to standard, leakage and short circuit will occur after a period of use, and it also uses the same power supply as other electrical appliances in the store. When those high-power appliances such as refrigerators and air conditioners are turned on at the same time, the When the phenomenon of electricity overload occurs, the load current of the main power supply is too large to withstand such a large current.
Therefore, when installing the clothing security door, the power wiring is very important. It must be powered by an independent power supply. The power box uses a two-pole grounding plug to avoid mutual interference with other electrical appliances. The power socket used must meet the safety standards. grounded socket. When all the connections have been connected, it is necessary to repeatedly check the installation and the wiring is correct, so that the power can be turned on. When the clothing anti-theft device is powered on, if an abnormal phenomenon is found, the power supply must be cut off immediately, and then the power can be turned on after troubleshooting. Power-on test for about 30 minutes to see if the system is normal and then determine the installation location. Be sure to remember to use an independent power supply.